Cruise control operations
The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal.
To turn on the cruise control, push the ON·OFF switch on. The CRUISE indicator light in the vehicle information display will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release it. The SET indicator light in the vehicle information display will illuminate. Take your foot off the accelerator pedal. Your vehicle maintains the set speed.
● To pass another vehicle, depress the accelerator
pedal. When you release the
pedal, the vehicle returns to the previously
set speed.
● The vehicle may not maintain the set speed
when going up or down steep hills. If this
happens, drive without the cruise control.
To cancel the preset speed, use one of the following three methods.
● Push the CANCEL button; the SET indicator
light in the vehicle information display goes
out.
● Tap the brake pedal; the SET indicator light
goes out.
● Push the ON·OFF switch off. Both the
CRUISE indicator light and SET indicator
light in the vehicle information display go out.
The cruise control is automatically canceled and the SET light in the vehicle information display goes out if:
● you depress the brake pedal while pushing the ACCEL/RES or SET/COAST switch.
The preset speed is deleted from memory.
● the vehicle slows down more than 8 MPH
(13 km/h) below the set speed.
● you move the shift selector to N (Neutral).
To reset at a faster cruising speed, use one of the following three methods.
● Depress the accelerator pedal. When the
vehicle attains the desired speed, push and
release the COAST/SET switch.
● Push and hold the ACCEL/RES switch.
When the vehicle attains the speed you desire,
release the switch.
● Push and release the ACCEL/RES switch.
Each time you do this, the set speed increases by about 1 MPH (1.6 km/h).
To reset at a slower cruising speed, use one of the following three methods.
● Lightly tap the brake pedal. When the vehicle
attains the desired speed, push the
COAST/SET switch and release it.
● Push and hold the COAST/SET switch. Release
the switch when the vehicle slows to
the desired speed.
● Push and release the COAST/SET switch.
Each time you do this, the set speed decreases by about 1 MPH (1.6 km/h).
To resume the preset speed, push and release the ACCEL/RES switch. The vehicle returns to the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h).
See also:
Operating tip
• When the shift lever is shifted to the
R
(Reverse) position, the monitor screen automatically
changes to the RearView Monitor
mode. However, the radio can be heard.
• When the view is swit ...
Steering wheel
Do not adjust the steering wheel while driving. You could lose control of
your vehicle and cause an accident.
Tilt operation
Tilt operation
Pull the lock lever down 1 and adjust the steering ...
Loading tips
• The GVW must not exceed GVWR or
GAWR as specified on the F.M.V.S.S./
C.M.V.S.S. certification label.
• Do not load the front and rear axle to
the GAWR. Doing so will exceed the
GVWR.
WARNI ...