Manual operation

Fan speed control

Turn the “dial to ” fan speed control dial to manually control the fan speed.

Push the “AUTO” button to return to automatic control of the fan speed.

Air recirculation

Push the intake air control button “ recirculate interior air inside the vehicle. The” to recirculate interior air inside the vehicle. The indicator light “ ” will come on.

The air recirculation mode cannot be activated when the air conditioner is in the front defrosting mode “ Outside air circulation”.

Outside air circulation

Push the intake air control button “” to ” to change the air circulation from the intake air to the outside air. The indicator light “ off.” will turn off.

Automatic air intake control

In the AUTO mode, the intake air will be controlled automatically. To manually control the intake air, push the intake air control button “control mode, ”. To return to the automatic control mode, push the intake air control button “ about 2 seconds. The indicator lights will flash” for about 2 seconds. The indicator lights will flash twice, and then the intake air will be controlled automatically.

Air flow control

Pushing the “MODE” manual air flow control button selects the air outlet to:

ventilators.: Air flows from center and side ventilators.
ventilators: Air flows from center and side ventilators and foot outlets.
outlets.: Air flows mainly from foot outlets.
outlets.: Air flows from defroster and foot outlets.

Upper vent system

When the “button is ” upper vent system button is pushed, the air flow against the driver’s or passenger’s upper body becomes gentle. The indicator light on the button will come on.

In this mode, air from the center ventilators flows both straight and upward in order to control the cabin temperature without blowing air directly on the occupants.

If you want strong air flow against your upper body, push the “the indicator ” button to turn the indicator light off.

    See also:

    Child safety rear door lock
    Child safety locks help prevent the rear doors from being opened accidentally, especially when small children are in the vehicle. The child safety lock levers are located on the edge of the re ...

    Rear-facing child restraint installation using the seat belts
    WARNING • The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not ...

    Clearing the programmed information
    The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see “Reprogramming a single Ho ...