Locking with mechanical key
The power door lock system allows you to lock or unlock all doors simultaneously using the mechanical key.
Hardtop models
• Turning the driver’s
door key cylinder to the
front of the vehicle1 will lock all doors.
• Turning the driver’s door key
cylinder once
to the rear of the vehicle2 will unlock the
driver’s door. After returning the key to the
neutral position 3 , turning it to the rear
again within 5 seconds will unlock all doors.
Crosscabriolet models
• Turning the driver’s door
key cylinder to the
rear of the vehicle2 will lock all doors.
• Turning the driver’s door key
cylinder once
to the front of the vehicle1 will unlock the
driver’s door. After returning the key to the
neutral position 3 , turning it to the front
again within 5 seconds will unlock all doors.
Models with color display:
You can switch the lock system to the mode that allows you to open all the doors when the key is turned once. (See “How to use SETTING button” in the “4. Monitor, heater, air conditioner, audio, phone and voice recognition systems” section.)
See also:
NISSAN Voice Recognition Standard Mode
The Standard Mode enables control of navigation,
phone and vehicle information. With this
setting active, commands that are available are
always shown on the display and announced by
the system.
...
Emergency engine shut off
To shut off the engine in an emergency situation
while driving perform the following procedure:
• Rapidly push the push-button
ignition switch
3 consecutive times in less than 1.5
seconds, or
...
Passenger compartment
CAUTION
Never use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not ...