Programming troubleshooting
If the HomeLink® does not quickly learn the hand-held transmitter information:
• replace the
hand-held transmitter batteries
with new batteries.
• position the
hand-held transmitter with its
battery area facing away from the
HomeLink® surface.
• press and hold
both the HomeLink® and
hand-held transmitter buttons without interruption.
• position the
hand-held transmitter 1-3 in
(26-76 mm) away from the HomeLink®
surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink® is not
programmed within that time, try holding the
transmitter in another position - keeping the
indicator light in view at all times.
If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or 1-800-355-3515.
See also:
Forward-facing child restraint installation using
LATCH (Hardtop models only)
Refer to all Warnings and Cautions in the “Child
safety” and “Child restraints” sections before
installing a child restraint.
Follow these steps to install a forward-facing
child restrai ...
Push-button ignition switch positions
LOCK (Normal parking position)
The ignition switch can only be locked in this
position.
The ignition switch will be unlocked when it is
pushed to the ACC position while carrying the
Intelligent ...
Reporting safety defects
For USA
If you believe that your vehicle has a defect
which could cause a crash or could
cause injury or death, you should immediately
inform the National Highway Traffic
Safety Administration (N ...